Spreads like paste, hardens into metal. Adheres to metal, wood, plastic, glass. Apply right from the can. No mixing of two parts, no measuring or heat required. Lab-metal can be milled, drilled, tapped, ground, and sanded smooth. Will not shrink or crack. Water resistant, rustproof. Withstands heat to 350ºF and cold to -40ºF. Thin with Lab-solvent for brushing or spraying a metallic coating. Many applications may be made from a single can -- simply add Lab-solvent before covering. Workability of Lab-metal is enhanced by dipping applicator into Lab-solvent. Durable, permanent filler for patching seams and cracks; rebuilding worn metal surfaces; repairing dented metal; finishing welds; filling holes and imperfections in metal castings; repairing parts prior to powder coating. Lab-metal is not intended to be used as an adhesive.

PRODUCT SUMMARY: Easy to use Lab-metal fills dents and flaws in metal and nonmetal parts easily and economically. Apply Lab-metal right from the can with a putty knife or similar tool. No two-component mixing or measuring is necessary, therefore there is no waste. Heat, special tools and specialized skill are unnecessary. Many applications may be made from a single can. Thin to brush or spray Lab-metal may be thinned to paint consistency with Lab-solvent and brushed or sprayed on practically any surface to provide a rustproof, water resistant, hard metal finish. Bonds permanently Lab-metal adheres to any clean and dry metal, wood, glass, plaster, porcelain and hard plastic surface. Its strong bond withstands vibration and other difficult conditions. Lab-metal hardens quickly without heat, providing a durable metal surface. (See drying time in technical data section). Durable Once hardened, Lab-metal can be milled, chiseled, drilled, sawed, tapped and machined. Filing, sanding or grinding Lab-metal to a feather edge provides a smooth metallic repair. Lab-metal will not shrink, crack or peel. Not affected by mild acids, gasoline, oil or petroleum solvents. Lab-metal is aluminum filled, resisting attack of rust, rot and mildew. Lab-metal withstands temperatures as high as 350ºF (and as low as -40oF) and when hard, can be painted with lacquer or enamel without danger of bubbling, lifting paint, chipping or peeling. Lab-metal stands up to normal paint baking procedures and may also be powder coated (see special powder coating instructions). Efficient, economical Lab-metal’s true metal hardness is achieved with greater ease than other materials sold for repair and finishing. Lab-metal sells for considerably less than epoxy systems. Its strength, hardness, durability and abrasion resistance surpass basic requirements for fillers set by the nation’s largest metalworking plants. Lab-metal is the repair putty of choice because of its extensive can life, ready-to-use formulation, versatility of applications, and durability.